Addressable 4 Way Mimic Relay Board (4 In, 4 Out) – CIOP4

Eaton’s addressable mimic relay boards are 4 and 8-way soft addressing output modules that incorporate integral short circuit isolators.

Both relay boards are fully compatible with the current range of Eaton addressable control panels. The units are suitable for switching low voltage (24Vdc at 1A maximum), via a set of non-latching relay contacts.

The flexibility of these modules is further enhanced by the fact that each output can be programmed for a range of triggers. These triggers are disablement, fault, fire, test panel, test zone pre-alarm, fire routing equipment, fire protection equipment and reset, with up to 16 different trigger sources per output.

Additional information
Order Code

CIOP4

System

Addressable

Product Type

Addressable Interfaces

Contact me about this Product
Name
Email
Phone
Enquiry

SYSTEM FLEXIBILITY

16 settings per output

VERSATILE

4 or 8 output versions

EASE OF WIRING

Pluggable terminals

Simple, flexible programming

The mimic relay board range is available in 4 and 8 relay versions, and can be programmed using the CF3000 programmable site installer software and downloaded using the RS232 port. The trigger source can be global, by panel, by loop, by zone or by address and the rule logic is available in both OR & AND functions.

Benefits

• Quick and simple to install
• Pluggable terminals for ease of wiring
• Programmable via site installer software
• Cost effective installation solution

Configuration Instructions

1. At the mimic relay board:
– Change the jumper on J10 from LOOP to RS232 SETUP and place a jumper on J2.
– Press the RESET button on the mimic relay board and connect a serial cable.
2. In site installer:
– The configuration is not stored in the control panel and must be downloaded to the mimic hardware directly.
– “right-click” on the icon within site installer and select “upload rules to repeater”.
– The download from site installer will commence and a confirmation message will be displayed if successful.
3. At the mimic relay board:
– Remove the serial cable to the graphical relay board.
– Change the jumper on J10 from RS232 SETUP back to LOOP and remove the jumper on J2.

Features

• Loop powered
• Units can be soft or hard addressed
• Integral short circuit isolator
• Single address
• 4 input, 4 output version
• 4 input, 8 output version
• PCB version incorporates 4 inputs:
– Reset
– Silence
– Evacuate
– Test
• 16 settings per output
• Trigger types: fire, fault, disablement, test, prealarm, FRE, FPE, reset
• Trigger source: global, by panel, by loop, by zone,
by address
• Logic functions (OR and AND)

4 Way Mimic Relay Board, 4 Inputs, 4 OutputsCIOP4
8 Way Mimic Relay Board, 4 Inputs, 8 OutputsCIOP8
CIOP4 & CIOP8
Operating Voltage:24Vdc to 30Vdc
Operating Loop Voltage:18Vdc to 30Vdc
Current:1A (max)
Quiescent Current:6mA (nom)
Humidity (Non-condensing):0 to 95% RH
Construction:Boxed – ABS
Dimensions (HxWxD):Boxed – 180mm x 254mm x 90mm
Board – 113mm x 163mm
Weight:Boxed – 1.2kg
Board – 1.0kg
Ingress Protection:Boxed – IP65
Suitable for use with:Eaton Addressable Fire Systems

DOWNLOADS

TEL: 254-774-211313

close
Start typing to see posts you are looking for.
Set your categories menu in Theme Settings -> Header -> Menu -> Mobile menu (categories)

Shopping cart

close
Scroll To Top