The loop tester kit is a hardware/software combination that can be used to test, commission and fault find a loop of up to 200 addressable devices (detectors, sounders, ancillary devices), without having to connect the loop to an Eaton addressable fire alarm system control panel.
Saving potential large amounts of time and as a consequence, money, compared to if a fault were to be identified after a being connected to the live system.
The loop tester is connected between the loop and PC. It allows the engineer to quickly identify and locate any loop device that is operating outside of its operating conditions, by varying the alarm threshold of any loop device (alarm, pre-alarm and fault).
| Order Code | LP800KIT |
|---|---|
| System | Addressable |
| Product Type | Addressable Installation Accessories |
Operate the LEDs of any inputs (detectors / call points)
Story a history of events from the date the application was started
Control sounders and output modules outputs
The loop tester kit acts as a trial run to check if there are any faults on a loop before a system is fitted.
The kit can be used as a convenient way to reassure installers and validate a loop before it gets connected to a live system.
| Loop Tester Kit | LP800KIT |
